Mimosa Network Documentation

 

Access Point - User Guide 

 

 

Accessing the Graphical User Interface

​

Accessing the graphical user interface (GUI) requires that the radio first be connected to power. The Power over Ethernet (PoE) connection process describes the steps to do this. Note that the GUI will be available approximately one minute after applying power.

 

The GUI can be accessed in three ways to facilitate set-up and management.

1. Locally through the 2.4 GHz or 5 GHz wireless SSID

2. Through the local Ethernet interface (LAN)

​

Via 2.4 GHz Management Network

On any device with 2.4 GHz 802.11n capability, go to the wireless network listing and connect to the Local Network Management wireless network (SSID):  "mimosaMXXX". The default passphrase for the 2.4 GHz connection is "mimosa123". Once connected, type 192.168.1.10 into your browser.  Please note that both the Local Network Management SSID and passphrase are configurable by the user, so their values could be different from the default values.  

Via Ethernet interface or in-band over the 5 GHz Wireless link

By default, the device IP address is 192.168.1.10 and can be accessed via the Ethernet port using this IP address in any standard Web browser.  To access the device via a locally connected computer initially (on the same LAN or directly to the Ethernet port), the computer’s IP address must be on the same subnet as the above address. Once you have modified the  device IP address (static or DHCP) for management purposes, the new IP address must be used to access the device.